E1 to ethernet protocol converter

protocol converter, E1 to 10/100BaseT, 2Mbps,desktop,Support frame length: minimum: 64 bytes, maximum: 1916 bytes. AC or DC  Order InformationZS-C8-FE1/ETH       Frame E1 to Ethernet (Transparent bridge mode or N*64K) ---------------------------------------------------------------------------------------------------------------------Product model: ZS-C8-FE1/ETH   Product DescriptionZS-C8 Series FE1 to Ethernet converter adopts telecom line (E1 or E1 transmitting network such as PDH, SDH, microwave, etc) to extend Ethernet. It converts Ethernet frame structure to E1 frame structure, and recovers E1 frame structure to Ethernet frame structure at the other side, which enables Ethernet data to transmit in telecom network based on E1. Because it is efficiently and effectively used the spared bandwidth of telecom providers, it saves the networking cost and improve the efficiency and can be used immediately. Technology Characteristics-> Support Ethernet data transmitting transparently or according to timeslots in E1 line; bandwidth ranges from 64Kbps-2048Kbps-> Support Ethernet auto-sensed and full/half duplex function-> Support MDI/MDI-X auto-sensed-> Support to transmit of extra long frames regulated by IEEE 802.1Q; support Ethernet switch with VLAN function-> Support data filter at local side-> Provide unbalanced 75Ω and balanced 120Ω E1 interfaces Interface ParametersE1 Interface:   -> Support ITU-T G.703 , G.704   -> HDB3 line coding, comply indication output of route warn   -> Coding rate : 2048Kbps±50ppm   -> 75Ω physics interface use BNC standard coaxial connector, 120Ω physics interface use RJ45 connectorEthernet Interface:   -> Fully IEEE 802.3 (2000) compliant   -> Bit rate: 10Mbps or 100Mbps   -> Interface type: RJ45-> Support frame length: minimum: 64 bytes, maximum: 1916 bytes.General characteristics-> Power : 220V±20% , -36 ~ -72V-> Power Consumption : < 5W-> Environment Temperature : 0°C-50°C-> Size : 220×175×35mm or 483×160×45(mm) -> Net Weight : 900gPacking List-> E1/Ethernet Protocol Converter-> One Power cord (Note : -48v no with power cord)-> Two BNCs Coaxial Connector-> Manual book

E1 to ethernet protocol converter